Filter
Top Products
FEATURES
DOMELIGHT SUPERVISION OUTPUT (optional)
When the unit is disarmed, the interior domelight will turn ON for about 16 seconds.
AEI (AUTOMATIC ENGINE IMMOBILISER)
AEI is a selectable feature that can automatically engage the starter disable. If this feature is
selected, 30 seconds after turning OFF ignition will activate AEI. With the alarm set at active
mode, 30 seconds after disarming will also activate AEI. This feature prevents your vehicle
from being stolen even when the system is in disarm mode. Once AEI is activated, the red
LED constantly stays ON.
QUIET MODE
For silent arming or disarming the system, press transmitter button 2 once before pressing
transmitter button 1. This can be cleared by turning on the ignition.
VALET MODE
You can prevent your system from arming by entering valet mode. This is useful when
unloading groceries or when having the car serviced. You can enter valet mode by perform-
ing the below procedures.
1. With the alarm disarmed, within 10 sec., switch ignition ON then OFF.
2. Right after turning off ignition, press and
hold over-ride switch. Two sec. after, siren will
begin chirping.
3. Wait for 1 chirp then release switch.
4. Turn on ignition. Siren will chirp once signifying that the system has entered valet mode.
To exit valet, repeat the above procedures. Instead of hearing 1 chirp in step 4, exit valet will
be indicated by 2 siren chirps.
PANIC MODE
In times of emergency, the system can be forced into trigger mode (siren sounding and
parklights flashing) to attract attention. This can be done by pressing transmitter
button 1 for 3 seconds.
2ND CHANNEL OUTPUT
To operate optional accessories like boot release, the system's 2nd channel output can be
used for such purpose. Pressing transmitter button 2 for 3 seconds activates the system's
2nd channel output.
The system will first disarm and unlock the doors. Then the boot opens.
2ND CAR OPERATION
The functions of the transmitter buttons 1 and 2 are interchangeable. When learning a new
transmitter, the button pressed will be the control button used in arming and disarming the
system.
LED STATUS INDICATOR
This system comes with a LED to indicate alarm status and other useful functions:
• Off F Disarmed
• Steady On when transmitter is pressed F RF Reception
• Slow Flash (Once per second) F Armed
• Fast Flash (4 times per second) F Arming
• Long Flash F Valet
• Steady On F AEI activated