Filter
Top Products
Step 1
Step 2
7
TM
Installing the GPS Device in Your Vehicle
Windshield Mounting
When you install the device for the rst time, attach the
device to the support arm before attaching the arm to your
vehicle windshield.
Note: Before attaching the suction cup, clean the inside
of your windshield with a standard window cleaner and a
lint-free cloth.
Extend the GPS antenna and insert the hooks on the
support arm into the holes on the bottom of the Device.
Squeeze the locking tabs together. Swing the top of the
support arm into the back of the device. Release the
locking tabs.
Place the suction cup at against the windshield, and
adjust the position so you can easily see the display screen
but your driving view is not obstructed. Flex the goose-
neck support arm until the display is in the right position.
1.
2.
3.
Press the suction cup
rmly against the
windshield and push
the suction lock up
towards the suction
cup. To release the
suction cup, pull the
lock back towards the
support arm and lift the
plastic tab. Important:
be ready to support the
device when it releases
from the windshield.
Connect the DC power cord to the 11-15VDC jack.
Then, insert the cigarrette-lighter plug into a standard
12-volt outlet. The device automatically turns on when
you connect the power.
4.
5.
Suction Lock
Release Tab
NOTE:
Some states (including California and Minnesota)
have banned the use of windshield-mounted devices
inside the state’s borders. It is your responsibility
to understand and comply with all the laws of any
state(s) in which you operate your vehicle.