Filter
Top Products
BATTERY CHARGING/CARE
BATTERY CHARGING/CARE
(Batteries and charger not included)
Your vehicle will not operate without the
TYCO
®
R/C TMH™ FlexPak™ Battery Pack
and 4 Hour Quick Charger.
The TMH™ FlexPak™ battery pack
is designed for use exclusively in
TYCO
®
R/C TMH™ power vehicles.
It will not work in any 6.0V or 9.6V NiCd
battery-powered vehicles.
Your TMH FlexPak battery pack
features a unique design (Patent Pending) which allows it to be configured in different ways for use in different
R/C vehicles. This feature allows maximum vehicle performance and design flexibility. To configure your
FlexPak battery pack for use in Nitro Dozer
™
, please refer to Step 2, “Battery Installation.”
1. Plug the battery charger into standard wall outlet.
2. Hold the battery pack fully open, with the metal contacts at the top, as shown. The labels
marked “1” and “2” in the upper left-hand corner should be facing you. Now slide the battery
pack securely into the charger.
3. To disconnect, push the red button on the side of the charger. Hold the red button down
while you slide out the battery pack.
4. New battery packs must be charged for 5 1/2 hours the first two times charged. After that,
subsequent charges will require only 4 hours.
5. After charging for 4 hours, the battery pack will feel warm. This is normal for fully charged
batteries.
6. Charging the battery pack for more than 4 hours will not give you longer running time.
7. Unlike alkaline batteries, which lose power gradually, your TMH FlexPak battery will run for
its normal running time, depending on your particular vehicle, and then lose most of its
power at once. It is now time to recharge the battery pack.
8. Unlike NiCd (Nickel-Cadmium) rechargeable batteries, your TMH FlexPak battery pack
may be recharged at any time, irrespective of the level of charge remaining in the battery:
you do not have to wait until the battery pack is fully discharged to recharge it.
9. After use, the battery pack will be hot! Wait at least 20 minutes until the battery pack cools
down before recharging. Recharging a hot battery pack will greatly reduce the number of
times your battery pack can be recharged.
BATTERY PACK CARE
Because of its unique design, other battery chargers will be unable to charge your TMH FlexPak battery pack.
To charge your battery pack, use only the TYCO R/C TMH FlexPak battery charger.
CAUTIONS
• DO NOT RECHARGE BATTERY PACK IF IT’S HOT. ALLOW IT TO COOL BEFORE RECHARGING.
• DO NOT CHARGE A BATTERY PACK THAT SHOWS LEAKAGE OR CORROSION.
• DO NOT DISASSEMBLE THE BATTERY PACK. THE BATTERY PACK IS A SEALED NiMH (NICKEL-METAL HYDRIDE) BATTERY.
• DO NOT DISPOSE OF THE BATTERY PACK IN FIRE.
• EXERCISE CAUTION IN HANDLING A HOT BATTERY PACK.
• IF BATTERY PACK AND/OR CHARGER ARE WET, THOROUGHLY DRY BEFORE CHARGING.
TMH
™
FlexPak
™
Battery
Pack and Charger
Additional TMH
™
FlexPak
™
Battery Pack
Have additional Battery
Packs charged ahead of time
for longer non-stop racing
action. Uses the TMH
™
Quick
Charger.
Unlike NiCd (Nickel-Cadmium)
rechargeable batteries, your TMH
FlexPak battery pack requires no
special procedures or precautions
for disposal. However, as with all
products, you should dispose of your
battery pack in an environmentally
responsible and considerate manner.
SPECIAL NOTE TO ADULTS:
• The battery charger is age-graded for ages 8 and over; the battery charger should not be
operated in the presence of children under 8 years of age without adult supervision.
Adult supervision is recommended.
• Regularly examine for damage to the plug, enclosure and other parts. In the event of any
damage, the toy must not be used with the transformer until the damage has been repaired.
• This toy is not intended for children under 3 years old. The transformer is not a toy.
™
™
™
™
1
2
ALSO AVAILABLE
1
2