Tyco 35464-1920 Motorized Toy Car User Manual


 
SYMPTOM PROBABLE CAUSE CORRECTION
TROUBLESHOOTING
OPERATING YOUR VEHICLE
OPERATING YOUR VEHICLE
TROUBLESHOOTING PROBLEM? – SOLUTIONS!
© 1998 Mattel, Inc., Mt. Laurel, NJ 08054 U.S.A. PRINTED IN CHINA.
All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
Retain this address for future reference: Mattel U.K., Ltd., Meridian West, Leicester LE3 2WT.
Mattel Australia Pty., Ltd., Richmond, Victoria 3121 - Consumer Advisory Service:
1800 800 812 (valid only in Australia). Mattel East Asia Limited, 930 Ocean Centre, Harbour City, HK, China.
In Britain 49 MHz is not available. 27 MHz can be raced against 40 MHz vehicles.
COMPLIANCE WITH FCC REGULATIONS
THIS DEVICE COMPLIES WITH PART 15 FCC RULES. OPERATION OF THIS DEVICE IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
1. THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE.
2. THIS DEVICE MUST ACCEPT ANY HARMFUL INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
This device generates and uses radio frequency energy and if not used properly may cause interference to radio and television
reception. It has been tested and found to comply with the limits set by the FCC which are designed to provide reasonable protection
against such interference.
CAUTION: FCC Regulations state that changes or modifications to this product not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Adults, this toy is recommended for children 5 years of age and older. To ensure that the
child’s play is both safe and fun, please review the operating instructions and these general
safety rules with the child.
Caution
DO NOT pick up vehicle while in motion.
Keep fingers, hair and loose clothing away from the tires and the wheel hubs while the
vehicle is switched “ON.”
If this toy is being operated in the presence of children under 5 years of age, adult
supervision is recommended.
To avoid accidental operation, remove Power Clip (or battery pack) when not in use.
Quick Reference
Tips & Hints
1.
The radio circuitry in your vehicle and transmitter is sensitive. Do not store vehicle
or transmitter near heat or in direct sunlight. If any moisture is present after use,
remove moisture from vehicle using a clean dry cloth. Avoid operating in snow.
2. Turn vehicle switch to the “OFF” position and remove Power Clip (or battery pack)
when not in use.
3. When your vehicle runs erratically, the problem is usually the result of interference
caused by high tension wires, CB radios, or other R/C vehicles running nearby on
the same frequency as yours. You may have to choose an alternative place to race.
1. (a) Insert 4 “AA” batteries in the 6.0V DP Power Clip and then install in vehicle;
OR
(b) Give your 6.0V Jet Turbo battery pack a full charge and then install in vehicle.
2. Turn vehicle switch “ON.”
3. (a) If using 6.0V DP Power Clip: your vehicle will lose power gradually as the “AA”
batteries weaken. When your vehicle begins to run slowly or stops altogether it is
time to change the “AA” batteries.
(b) If using 6.0V Jet Turbo Rechargeable NiCd battery pack: after its normal
running time, your vehicle will lose most of its power at once.
4. Turn vehicle switch “OFF.” Replace or recharge batteries for more action!
This section is only a quick reference guide. Please read this entire manual thoroughly
before operating your vehicle.
Safety Precautions
Vehicle runs slowly or will not run.
Erratic operation or only short range possible.
Short rechargeable NiCd battery life.
Vehicle doesn’t work after going through
water or snow.
• Loose battery connection or vehicle switch
not ON.
• Weak or uncharged rechargeable NiCd
battery.
• Weak “AA” batteries (Power Clip) or 9-volt
transmitter battery
• Radio interference likely.
• Battery not fully charged.
• Water in the electronics area.
• Check battery connector and vehicle
switch.
• Charge battery or replace.
• Replace with fresh alkaline battery.
• Change location (see point 3 - Tips &
Hints).
• Recharge vehicle battery.
• Vehicle will take several hours to dry.
Allow to dry overnight before trying again.
• Avoid driving in water and snow.
2. Radio interference can be caused
by the operation of your vehicle near
HIGH VOLTAGE ELECTRICAL
WIRES, LARGE STEEL
REINFORCED CONCRETE
BUILDINGS AND PASSING
TRUCKS WITH CB RADIOS.
Avoid these if possible.
3. DO NOT operate
your vehicle over wet
surfaces. Water can damage
the electronic assemblies.
5. For best results, hold
antenna up, not pointed down
toward R/C vehicle. If you drive
your vehicle TOO FAR
AWAY FROM THE
TRANSMITTER, your signal
strength will become weak and
vehicle will not function properly.
The maximum range for the
vehicle should be between
30'/10m to 65'/20m, when
operating outdoors.
1. Radio interference is caused by the
presence of another radio controlled
vehicle operating on the same frequency
as your vehicle. Multiple vehicles should
NOT BE OPERATED ON THE
SAME FREQUENCY at the same
time.
4.
DO NOT operate
your vehicle on streets!
They are for real cars.
65'/20m
30'/10m
SYMPTOM PROBABLE CAUSE CORRECTION