Filter
Top Products
7116" BOX END
WRENCH
NUT & WASHER
ASSEMBLY 1/4" .20
CRUISE CONTROL
MODULE CABLE
FIGURE 3
7. To use the Snap-In Adaptor, it will be necessary to fonn threads on the end of the Cruise Control Module Cable. This
is accomplished by placin.g the 1/4" -20 Nut and Washer Assembly on the end of the Cruise Control Module Cable with
your fingers, then use a 7/16" box end wrench and turn clockwise, until the desired amount of threads have been fonned
as shown in Figure 3. .
8. After the threads have been fonned thread the Snap-In Adaptor onto the Cruise Control Module Cable. and snap into
the Bracket-Cable as shown in Figure I.
~
9. Install Snap-In-Adapter in square hole of Bracket-Cable.
10. After everything has been secured, make sure that when the accelerator pedal is in its free undepressed state (hot idle) that
there is between .010" -.060" of slack between the ball on the end of the wire rope and the Bushing-Cable. See Figure
2. If adjustment is necessary , the Snap-in-Adapter can be turned (it's threaded so that it can be adjusted) clockwise or
counterclockwise to compensate. Secure Cable Assembly with Wire Ties.
II. Be sure that the throttle is not being held open by the Cruise Control Module Cable.
Form #2525
1/93
ALL RIGHTS RESERVED
PRINTED IN THE USA