Filter
Top Products
7/16" Box End
---r:Wrench
I
c-\
~
~L
Cruise Control
Cable
"""'
Nut and Washer
Assembly 114-20
FIGURE 2 .After Threading Cable
5. To use that Snap-In adaptor, it will be necessary to fonn threads on the end of the Cruise Control
Cable. This is accomplished by placing the 1/4"-20 Nut and Washer Assembly on the end of
the Cruise Control Cable with your fingers, then use a 7/16" box end wrench and turn clockwise, until the
desired amount of threads have been fonned as shown in Figure 2.
6. After the threads have been fonI1ed thread the Snap-In Adaptor onto the Cruise Control Cable, and
snap into the Bracket-Cable as shown in Figure I.
NOTE" ENSURE THAT AT LEAST 1/8" OF THE CRUISE CONTROL CABLE IS
EXPOSED PAST THE SNAP-IN ADAPTOR, SEE FIGURE I.
7. Connect the Bead Chain Eyelet Connector, to the Bead Chain with the Bead Chain Connector
Cover in place. Install Bead Chain Eyelet Connector with Bead Chain, Washer-#10 Plain on the
Bracket. Throttle Lever, and secure in place with Pin.Self Locking as shown in Figure 1.
8. Connect Bead Chain with Bead Chain Connector (Double Ended), to the Cruise Control Cable,
with no slack in the Bead Chain, and install a Bead Chain Connector Cover as shown in
Figure 1.
9. Be sure that the throttle is not being held open by the Cruise Control Cable. Adjust Cruise Control
Cable by releasing Snap-In Adaptor from Bracket-Cable to proper length.
Snap, Snap-In Adaptor back into Bracket-Cable.
ALL RIGHTS RESERVED
PRINTED IN THE USA