Filter
Top Products
6)
T o use the Snap-In Adaptor, it will be necessary to form threads on the end of the Cruise Control
Module Cable. This is accomptished by placing the 114"-20 Nut and Washer Assembly on the
end of the Cruise Control Module Cable with your fingers, then use a 7116" box end wrench and
turn clockwise, until the desired amount of threads have been formed as shown in Figure 2.
Before Threading Cable
7116" Box End Wrench
;-;
O:s::s::
---~
01143
Cruise Control Module
Cable
.
01150
, iI
After Threading Cable
FIGURE 2
7)
After the threads have been formed thread the Snap-In Adaptor onto the Cruise Control Module
C-~61e.andsnap in16~aCJ(et;;CaDTe~as shown in FIgtire 1. ---~ ~
8)
Connect the Bead Chain Eyelet Connector, to the Bead Chain with the Bead Chain Connector
Cover in place. Install Bead Chain Eyelet Connector with Bead Chain, Washer-#1 O Plain on the
Bracket- Throttle leve:r, and secure in place with Pln-Self Locking as shown in Figure 1.
9)
Connect Bead Chain with Bead Chain Connector (Double Ended), to the Cruise Control Module
Cable, with no slack in the Bead Chain, and install a Bead Chain Connector Cover as shown in
Figure 1.
10)
Be sure that the throttle is not being held open by the Cruise Control Module Cable. Adjust Cruise
Control Module Cable by releasing Snap-In Adaptor from Bracket-Cable and threading in or
out to adjust Cruise Control Module Cable to proper length. Snap, Snap-In Adaptor back into
Bracket-Cable.
Rostra Precision Controls, Inc. 1991
Printed In the United States of America
Form #2433
Nut and Washer Assembly
1/4-20