Toyota 250-4211 Automobile Parts User Manual


 
91/92 TOYOTA TERCEL WITH 1.5L FOUR CYLINDER
ENGINE THROTTLE
LEVER ADAPTOR PACKAGE
250-4211
1)
Remove the throttle shaft nut and lock washer from the throttle shaft. Install the Bracket- ThroUle
Lever on the throttle shaft. Reinstall the lock washer and hex nut, and torque the nut to 60- 72 In/
Lbs (5-6 Ft./Lbs), See Figure 1.
NOTE: START NUT BY HAND FIRST TO PREVENT CROSS THREADING. DO NOT
OVERTIGHTEN HEX NUT.
Th ttl B dPln-Self ro e o y
Locking" Bracke~- Throttle Pulley Assembly
'\\ Lever -I
(
Accelerator
Cable Bracket
Washer
Plain #10
~
~
.
,
Loosen This
, Nut.Qnly
v
Bead Chain Eyelet
Connector
Bead Chain
Adaptor
~
1/8" of Cable
Must Be Exposed
Bracket-Cable
Figure 1
Exploded View
Loosen the accelerator cable bracket jam nut. Loosen only the nut shown in Figure 1.
2)
Install Bracket-Cable between the cable bracket and the jam nut previously loosened.
Retighten jam nut ensuring that Bracket-Cable is held securly in place.
3)
Remove the Snap-In Adaptor from the Cruise Control kit.
4)
Remove the Adjustable Sleeve from the Cruise Control Module Cable and discard.
5)
Bead Chain
Connector Covers