Filter
Top Products
6)
To use the Snap-In Adaptor, it will be necessary to form threads on the end of the Cruise
Control Module Cable. This is accomplished by placing the 1/4" -20 Nut and Washer
Assembly on the end of the Cruise Control Module Cable With your fingers, then use a 7/16"
box end wrench and turn clockwise, until the desired amount of threads have been formed
as shown in Figure 2.
Before Threading Cable
/
/
01150
After Threading Cable
FIGURE 2
7) After the threads have been formed screw the Snap-In Adaptor onto the Cruise Control
Module Cable and snap into the BracItet-Cable as shown i~ Figure 1.
8)
Install the Bead Chain Eyelet Connector, with the Bead Chain and Bead Chain Connector
Cover in place, and the Washtt-- #10 Plain to the Bracket-Throttle Lever and install the
Pin- Self Locking as shown in Figure 1.
9)
Connect the Bead Chain with the Bead Chain Connector (Double Ended), to the Cruise
Control Module Cable, with no slack in Bead Chain, and install a Bead Chain Connector
Cover as shown in Figure 1.
10)
Be sure that the throttle is not being held open by the Cruise Control Cable. Adjust cable
by releasing Snap-in Adaptor from Bracket-Cable and threading in or out to adjust cable to
proper length. Snap Adaptor b~ck into "j'.J:a&et.