Filter
Top Products
1990 TOYOTA CELICA ST WITH 1.6 L ENGINE
THROTTLE LEVER ADAPTOR PACKAG~
250-4204 .
1)
Remove the throttle shaft nut and lock washer from the throttle shaft. Install the Bracket -
Throttle Lever. Reinstall the lock washer and hex nut, and torque the nut to 84 in-lb (7 ft-lb).
Note: Start the nut by hand to prevent cross-threading. Do not over tighten.
f
,~
FI6uRE 1
~
Bracket-Cable
I
1/8" of cable MUST
be exposed \
,~A
I r ~~ ,~
-I \~ r"
" 1'--
-~,
Bead Chain
Connector Covel\ \
\
I
I
I
I. i.,.-1-
'r -
I ~~j
~\~)
~)ml
\..4l1 !T ( .
:: I! III,: 1
II II
iv-I' II
\\IV, -
~
Snap-In
Adaptor
,,~
~
/
Bead Chain
Connector
Bead Chain ~ -
\ .~,
Bead Chain Eyelet
Connector
Bracket- Throttle
Lever
"
Washer-#10 Plain
,
INST ALLEQ VIEW
,
\
Pin-Self Locking
2)
3)
Loosen the accerator cable bracket jam nut. Loosen only the nut shown in Figure 1.
.~.;p
Install Bracket-Cable between the accelerator cable bracket and the jam nut previously
loosened and retighten the jam nut.
4)
Remove the Snap-In Adaptor from the Cruise Control Kit.
5)
Remove the Adjustable Sleeve from the Cruise Control Module Cable.
@ Dana Corporation 1990
All Rights Reserved
Printed in the United States of America
Form #2310
Loosen This Nut
ONLY