Filter
Top Products
Page 10 Two-Cycle Engine • Horizontal/Vertical Crankshaft • Air-Cooled 181-807-14
B. Stop Engine
1. Move equipment control, if present (see manufacturer’s
instructions) engine control lever or ignition switch to
“STOP” or “OFF” position.
2. Remove ignition key, if provided (see manufacturer’s
instructions).
NOTE
Removing key will reduce the possibility of unauthorized
starting of the engine while equipment is not in use.
NEVER store engine with fuel in the
fuel tank inside a building with
potential sources of ignition such as hot water or space
heaters, clothes dryers, electric motors, etc. Doing so may
lead to an explosion resulting in death or serious injury.
C. After Engine is Stopped
To prevent possible freeze-up of engine
controls, follow instructions with engine
stopped, listed below.
1. Wipe all snow and moisture from engine control lever
and choke areas.
2. Move equipment control, if present (see manufacturer’s
instructions) engine control lever or ignition switch back
and forth several times and leave control in “STOP” or
“OFF” position.
3. Move engine choke back and forth several times and
leave in the “FULL CHOKE” position. See Figure 15.
WARNING
CAUTION
Figure 15. Choke Control Positions
1. “NO CHOKE” Position
2. “1/2 CHOKE” Position
3. “FULL CHOKE” Position
1
3
2