Filter
Top Products
181-1132-14 Four-Cycle Engine • Vertical Crankshaft • Air-Cooled Page 7
II. Independent Speed and Choke Controls
1. To avoid carbon monoxide poisoning, be sure engine is
outdoors in a well-ventilated area.
2. Move independent speed control to “FAST” position
and set independent choke control to “FULL CHOKE”
position (see equipment manufacturer’s instructions).
See Figures 9 thru 11.
NOTES
Generator and Water Pump applications may have the
choke lever mounted on the engine. See Figure 12.
If restarting a warm engine after a short shutdown, move
independent speed control to “FAST” position and move
independent choke control to “NO CHOKE” position.
3. Push starter button or turn ignition switch key (see
equipment manufacturer’s instructions) to start engine.
NOTES
DO NOT operate an electric starter for more than 5 seconds
each attempt.
If engine fails to start after 3 attempts repeat steps 2 thru 3.
4. When engine starts:
a. Release starter button or ignition switch key.
b. Next, move independent choke control to “1/2
CHOKE” position until engine runs smoothly.
c. Next, move independent choke control to “NO
CHOKE” position.
5. Finally, move independent speed control to desired
speed in “RUN” range.
NOTES
If engine starts, but falters when independent choke control
is moved to “NO CHOKE” position:
a. Momentarily move independent choke control back
to “FULL CHOKE” position.
b. Next, move independent choke control to
“1/2 CHOKE” position until engine runs smoothly.
c. Finally, move independent choke control to “NO
CHOKE” position.
If engine dies after independent choke control is moved to
“NO CHOKE” position, repeat steps 2 thru 5 to restart
engine.
6. If engine fires but does NOT continue to run, move
independent choke control to “NO CHOKE” position
and start engine.
7. If engine fails to start after 3 attempts in the “NO
CHOKE” position, move independent choke control to
“FULL CHOKE” position and start engine.
8. If engine does NOT start after following steps 1 thru 7,
contact your Authorized Tecumseh Servicing Dealer.
DO NOT attempt to start or troubleshoot this engine in
any other way
.
Figure 10. Independent Speed and Choke Controls
Figure 11. Choke Control Positions
Figure 12. Engine Mounted Choke Lever
Choke
Control
Speed
Control
1 2 3
1. “NO CHOKE” Position
2. “1/2 CHOKE” Position
3. “FULL CHOKE” Position
1 2 3
1. “NO CHOKE” Position
2. “1/2 CHOKE” Position
3. “FULL CHOKE” Position