Filter
Top Products
Page 16 4-Cycle • Snow King Engine 181-1275-14
B. After Engine is Stopped
To prevent possible freeze-up of engine
controls, follow instructions with engine
STOPPED, listed below.
1. Wipe all snow and moisture from engine control lever
and choke areas.
2. Move equipment control, if present (see manufacturer’s
instructions), engine control lever or ignition switch
back and forth several times and leave control in
“STOP” or “OFF” position. See Figure 33.
3. Move engine choke back and forth several times and
leave in the “FULL CHOKE” position. See Figure 24
on page 12. Afterward, continue reading instructions
below.
4. Be sure fuel valve, if present (see equipment manufac-
turer’s instructions) is in “OFF” position. See Figure 34.
NEVER store engine with fuel in the
fuel tank inside a building with
potential sources of ignition such as hot water or space
heaters, clothes dryers, electric motors, etc. Doing so may
lead to an explosion resulting in death or serious injury.
CAUTION
WARNING
Figure 33. Engine Speed Control Positions
Figure 34. Fuel Valve Positions
STOP
1. Engine Speed Control
2. “STOP” Position
3. “SLOW” Position
4. “RUN” Range
5. “FAST” Position
3
2
1
5
4
Fuel Tank
Fuel Valve “OPEN”
Position Shown
Turn Valve
Clockwise To
“OFF” Position