Filter
Top Products
264v11,12 - page 14 (Black)
Screen angle and frequency: 45.0000, 150.0000
14
ADJUSTMENTS
THROTTLE ADJUSTMENT
If the engine does not start or if it runs roughly, the remote
throttle control may need adjustment. See your authorized
Briggs & Stratton dealer or follow the instructions below.
WARNING
Prevent unintentional starting.
Before performing adjustments:
• Remove spark plug wire from spark plug.
• Disconnect battery at negative terminal (only
engines with electric start).
TO ADJUST REMOTE THROTTLE*
[1] Loosen casing clamp screw.
[2] Move governor control lever, wire, and casing as
far as possible in direction shown.
[3] Move remote throttle control to FAST and tighten
casing clamp screw.
[4] Move throttle to STOP (if equipped).
GOVERNOR
CONTROL
LEVER
CASING
CLAMP
SCREW
WIRE &
CASING
* On some models the governor lever is bent into position
and is not adjustable.
TO ADJUST STOP SWITCH
[1] Governor control lever should make good contact
with stop switch. Check operation of throttle.
[2] Readjust if necessary.
GOVERNOR
CONTROL
LEVER
STOP
SWITCH
CARBURETOR ADJUSTMENT
WARNING
The manufacturer of the equipment on which this
engine is installed specifies top speed at which the
engine will be operated. DO NOT EXCEED this speed.
Fuel/air mixture on this engine is not adjustable. If speed
adjustment is required, see your Authorized Briggs &
Stratton Service Dealer.
Note: Engines operated at about 3000 to 5000 feet (900 to
1500 meters) above sea level may require a high altitude car-
buretor main jet. If erratic performance is observed, contact a
Briggs & Stratton Authorized Service Dealer for cost to install/
purchase a high altitude carburetor main jet, if available.