Filter
Top Products
17
CAUTION:
If the tightening angle of crankshaft pulley bolt
is less than 45 degrees, the bolt should be damaged.
In this case, the bolt must be replaced.
(8) Replace the crankshaft pulley bolts and
clean them.
Crankshaft pulley bolt:
12369AA011
(9) Clean the crankshaft thread using an air
jet.
(10) Tighten the bolts temporarily with tightening
torque of 44 N·m (4.5 kgf-m, 33 ft-lb).
(11) Tighten the crankshaft pulley bolts keeping
them in an angle between 65 degrees and 75
degrees.
CAUTION:
Conduct the tightening procedures by confirming
the turning angle of the crankshaft pulley
bolt referring to the gauge indicated on the belt
cover.
12) Install the A/C belt tensioner.
13) Install the A/C belt.
14) Install the Alternator / Power Steering belt.
15) Tighten the slider bolt (B) until belt is snug.
16) Tighten the lock bolt (A).