Subaru H7110FS400 Automobile Alarm User Manual


 
8
I. Shock Sensor Adjustment-ONLY IF REQUIRED
The factory has preset the sensitivity of the shock sensor at the time of manufacture. Under normal
circumstances the sensitivity should not require any adjustment and should be left untouched.
However, in the unlikely event that adjustment is required, please follow the steps outlined below.
1. Carefully remove the seal covering the shock sensor adjustment hole on the top of the security
module.
2. Using a #0 flat-tip screwdriver, CAREFULL
Y AND GENTLY adjust the sensitivity.
CW (clockwise) –INCREASES sensitivity
CCW (counterclockwise) –DECREASES sensitivity
3. With each adjustment of the control, repeat section I. Shock Sensor Test, to determine if the
desired sensitivity has been reached.
CAUTION: DO NOT make the sensitivity of the unit overly sensitive. Too high
a sensitivity setting will result in false alarms and provides no rela-
tive increase in the overall measure of security.
4. Upon completion of the sensitivity adjustment, place a small piece of electrical tape over the
sensitivity adjustment hole to prevent dust and/or other foreign material from entering the unit.
J. Finishing the Installation
1. Reverse steps 1, 2, 3, 4, 9 and 10 in section B.
2. Place the window decals on the inside of the rear passenger windows at the lower-front edge of
each window. The bottom edge of the decal should be one (1) inch from the bottom of the win-
dow, and the front edge of the decal should be one (1) inch from the front of the window. Make
sure that the window is clean and the decal is square and straight before adhering to the win-
dow.
Installation is now complete.