Filter
Top Products
-
15
-
CLEANING FUEL FILTER
Remove the hose clamp and pull out
the fuel filter from fuel pipe.
Wash the fuel filter with kerosene.
After washing, reassemble it.
If the fuel filter is heavy dirty, replace it
with new one.
CLEANING AIR CLEANER
Dirty air cleaner element will cause
starting difficulty, power loss, engine
malfunctions, and shorten engine life
extremely. Keep the air cleaner
element clean.
Remove the fixing bolt of air cleaner
cover.
Pull out the lower edge of the cover
to remove the air cleaner cover.
Place the choke lever to the fully
closed position, taking care to ensure
that dust and dirt are not allowed to
enter the carburetor.
Remove the element, then clean it
with a solution of warm water and a
mild detergent, thoroughly drying it
afterward. Install it in alignment with
the lines as shown in illustration.
Wipe off any oil adhering to the area
around the air cleaner cover and
breather with a cloth.
After cleaning, reassemble the
cleaner cover (insert the tab at the
top first, then insert the bottom tab)
and tighten the fixing bolt.
Air cleaner cover
Element
Choke lever
Fixing bolt
Breather
Air cleaner cover
Element
Place so that the
cutout is here (top left)
Choke lever
Fixing bolt
Breather
Line
(
the slash mark
)
Element
(
the dotted line
)
EH025
EH035