Filter
Top Products
Spin Master Ltd., 450 Front Street West, Toronto, ON M5V 1B6 Canada
Spin Master Inc., PMB #10053, 300 International Drive, Suite 100, Williamsville, NY 14221, USA
Spin Master Toys Far East Limited. Rm #1113, 11/F, Chinachem Golden Plaza, 77 Mody Rd.,
Tsimshatsui E., Kowloon, HK
Spin Master Toys UK Ltd., Meadowbank, Furlong Road, Bourne End, Bucks, SL8 5AJ,
United Kingdom
Spin Master France – 36 rue de Silly – 92100 Boulogne Billancourt – France
North American Consumer Information
Phone: 1-800-622-8339
www.spinmaster.com
TM and © 2007 Spin Master Ltd. Air Hogs ® is a
registered trademark of Spin Master Ltd. All rights reserved.
Conforms to product safety standards ASTM F963,
EN71 regulatory requirements. Products and colors may
vary. Please retain this information for future reference.
Patent Pending. MADE IN CHINA.
#20010685 NEN REV 2
TM
Safety Precautions:
Battery requirement for Controller/charger:
Power Supply :
Rating : DC 9 V, 0,45 W
Batteries : 6 x 1.5 V "AA"/LR6/AM3
Requires 6 x 1.5 V "AA" size batteries (not included)
Battery requirement for Havoc Stinger™:
Power Supply :
Rating : DC 3.7 V, 1,8 W
Batteries : 1 x 3.7 V Li-Poly Rechargeable Battery Pack
Requires 1 x 3.7 V Li-Poly Rechargeable Battery Pack (included)
Helicopter is equipped with a Li-Poly rechargeable battery,
please also pay attention to the following cautions for safety use:
- Do not dispose the battery in fire or heat.
- Do not use or leave the battery near a heat source such as fire or heater.
- Do not strike or throw the battery against hard surface.
- Do not immerse the battery in water, and keep the battery in a cool dry environment.
- When recharging, only use the battery charger specifically for that purpose.
- Do not over-discharge the battery.
- Do not connect the battery to an electrical outlet.
- Do not directly solder the battery and pierce the battery with a nail or other sharp object.
- Do not transport or store the battery together with metal objects such as necklaces, hairpins etc.
- Do not disassemble or alter the battery.
- Charge the battery every 6 months.
- Turn off your equipment power switch after use.
- As for a used battery, please recycle after covering the battery terminals with insulation tape or inserting it
to an individual poly-bag.
Battery Cautions:
- Non-rechargeable batteries are not to be recharged
- Rechargeable batteries are to be removed from the toy before being charged
(controller/charger only).
- Rechargeable batteries are only to be charged by an adult
- Different types of batteries or new and used batteries are not to be mixed (controller/charger only).
- Only batteries of the same or equivalent type as recommended are to be used.
- Batteries are to be inserted with correct polarity.
- Exhausted batteries are to be removed from the toy (controller/charger only).
- The supply terminals are not to be short-circuited.
Care and Maintenance:
- Always remove batteries from the toy when it is not being used for a long period of time.
(controller/charger only)
- Wipe the toy gently with a clean damp cloth.
- Keep the toy away from direct heat.
- Do not submerge the toy into water that can damage the electronic assemblies.
Note:
- Parental guidance is recommended when installing or replacing batteries.
- Under the environment with electrostatic discharge, the sample may malfunction and
require user to reset the sample.
Special Note to Adults:
- Regularly examine for damage to the plug, enclosure and other parts. In the event of
any damage, the toy must not be used with the controller/charger charger until the
damage has been repaired.
- This toy is not intended for children under 3 years old.
- This toy must only be used with the recommended charger
- Do not try to charge other batteries with controller/charger.
FCC Statements
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
-
Keep hands, hair and loose clothing away from the propeller when power switch is turned ON.
-
Turn off controller/charger and helicopter when not in use
-
Remove battery from controller/charger when not in use.
-
Parental guidance is recommended for the flight.
-
Keep your helicopter in your sight so that you can supervise it all the time.
-
New and alkaline batteries are recommended for use in controller/charger to obtain best and maximum performance.
-
You are advised to replace with new batteries as soon as the function becomes impaired.
-
Users should keep and retain this information for future reference.
-
Users should keep strict accordance with the instruction manual while operation the product.
-
Your controller/charger is tailor-made for the Li-Poly rechargeable battery used in Havoc Stinger™. Do not use it to charge
any battery other than that in the helicopter.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
1)This device may not cause harmful interference, and
2)This device must accept any interference received, including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
T
ROUBLESHOOTING Cont’d
The Helicopter is not reacting to the
controller.
Helicopter is losing control.
Helicopter is not holding a charge.
Helicopter will not lift off the ground.
Helicopter only turns in one direction.
Helicopter will not move forward or
backwards.
PROBLEM
A,B,C channel selection on controller is not
correct.
Helicopter may not be turned ON.
May be another infrared (IR) device using
the same channel.
Bright lights may be affecting the IR control.
You may be too far away from the controller.
Helicopter might be turned ON while charging.
Controller/charger is low on battery power.
Helicopter may not be fully charged.
Helicopter is not trimmed correctly.
Helicopter may not be properly weighted.
NOTE: Helicopter only moves forward and
sideways.
CAUSE
Double check the letter on the bottom of the helicopter
and adjust the channel selector on the controller.
Turn helicopter ON.
Avoid these if possible, or choose another place to
operate the helicopter.
Turn down lights or change flight environment.
Stay closer to the helicopter with the controller.
Turn OFF the helicopter so that it is not flashing.
Replace batteries in the controller.
Charge helicopter fully, until green light turns off.
Refer to the TRIMMING section in the instruction sheet.
Apply a silver aluminum sticker (included in box) to the
nose of the helicopter.
SOLUTION
For further questions and problems, please visit our website www.airhogs.com.