Filter
Top Products
7. If tape holds bottom drawer cover to drawer supports,
remove the tape Pull drawer partway out, Reach in, push
the rear of the glass up and, at the same time, back, until
it clears front-corner retainers
8oTilt and remove the cover,
9. Tilt and remove the drawer_
After cleaning, replace drawers and covers in reverse
order, Reinstall the gasket at the rear of the top drawer_
Fitthe end of the plastic drawer support into the slot on
the gasket, with the rubber
gasket flap facing you Make
sure the gasket snaps into
place.
Then replace the light panel
by hanging top of panel on
upper pins and pushing in at
bottom_
Drain Opening in Freezer Compartment
When cleaning, remove the
freezer bin and flush a
solution of baking soda (one
teaspoon) and two cups of
hot (not boiling) water
through the drain line with the
help of a meat baster, This
will help eliminate odor and
reduce the likelihood of a
clogged drain line.
If drain becomes clogged, use a meat baster and baking-
soda-and-water solution to force the clog through the
drain llne
Condenser
The condenser is located
behind the base grille For
most efficient operation,
remove the base grille (see
page 3) and sweep away or
vacuum up dust that is readily
accessible° For best results,
use a brush specially Condenser
designed for this purpose
It is available at your Sears store or service center This
easy cleaning operation should be done at least once a
year.
Behind Refrigerator
Take care moving your refrigerator away from the wall,
All types of floor coverings can be damaged, particularly
cushioned coverings and those with embossed surfaces
Pull the refrigerator straight out and return it to position by
pushing it straight in, Moving refrigerator in a side
direction may damage floor covering or refrigerator,
Light Bulb Replacement
Unplug refrigerator before changing a light bulb.
Fresh Food Compartment Interior
1. To align the control knob
properly, note position of
numbered control for proper
reassembly and pull off
knob
2, Pull bottom of light panel
down about 1/4-inch-just
enough to disengage lip at
rear from grooves in retainers on rear wall
3, Lift panel to disengage top from pins on side walls and
remove panel
After replacing with same size bulb, reinstall panel (hang
top on pins; pull bottom down, push it back and release it
to let lip engage grooves in retainers) Replace
temperature contro! knob in OFF position, turn it to
previous setting, and plug refrigerator back in
Freezer Compartment
t. Remove shelf iust
below light panel (Shelf
will be easier to remove
if it is emptied first,)
2o Pull plastic light panel
toward you, (It will bend to
free tabs from grooves )
3. After replacing with same size bulb, reinstall panel
and shelf
13