Filter
Top Products
4-Door Vehicle Instruction Sheet
MOUNTING WITH STRAP KIT # 7228
Used with Model 300.7271 (18 cu.ft.)
Strap Kit Contents
D_,SCRIPTION PART NO. QUAN
Gray Straps. 42" 00286 4 (A)
*Black Sla'aps - 48" 04865 2 (B)
Suap Bracket 04866 4 (C)
*slide Bracket 04867 2 (D)
Sponge Foot Pad* 00264 16 (E)
Gzay Boh Covers 02985 8 (F)
Hardware Bag 04872 1
Instruction Sheet 04868 I
(w) Reflects parts nat used with mounting _ 4-Door vehicles
M0untintr InstruetloM rot 4 Door Sedans
I. Turn assembled carrier upside down and place foot pads (E)
on the tai.*ed section of the inverted carrier bottom _ shown in
Fisure L
2. Attach strap braekeu (C) to bottom of comer with screws,
Large washers, and large plastic insert nuts. See Figure 2. Place
Gray bolt covers ('F) over bolts att_ohiag the strap brackets (C),
cm the imidc of the carrier bottom to prevent po_ible damage
to contents. Note: plasdc insert nuts are meant to hold very
aooarely, S_ews cmmOt be tightened by hand, they must be
driven through with a screwdriver and pliers or adju._table
w_ench.
3. Route gray straps (A) through the strap brackets and
mortaring hook as shown on Figure 3,
4. Center career on roof. NOTE: HffPE C£EANAI_4 OF
ROOF UNDER FOOT PADS,
5. Put mountin E hooks over external gutter or beneath door
frame, Pull bottom portion of loops towards you to center the
carrier and to dghte_ See Figure 4. When tight, pull strap end
toward carrier. To prevent flapping, wrap straps around buckle
area and tie off loose ends.
6. Mounting straps should be redghteued after carrier is loaded
and periodically check-ed for tightne= when IQraveling. FOR
SAFETY, THE C.4RJUER LOCES MUST BE PROPER£ Y
ENOAOED AND THE FRONT ,4HD RF-.4g BLACK
L_I TCHP_9 CLOSED IVHENEVJ_R THE Y_HIC£E IS IN
MOTION,
I Save this lmtmction sheet for _nm: reference.
R_lac_acnt partsareavailablethrough Scm PortoDepartment,800-366-7278
_g_el
Figure 2
-.--tmeml_
\
(A)