Galaxy 5000RS Plus - Page 7
Tamper Alert
If the system was triggered while away, the LED will flash to indicate which zone triggered the system after
disarming and turning on the ignition. The LED indication will repeat 8 times.
LED Flashes (60 seconds):
1 flash = optional sensor
2 flashes = shock sensor
3 flashes = network based sensor
4 flashes = door
5 flashes = trunk
6 flashes = reserved for future use
7 flashes = reserved for future use
8 flashes = reserved for future use
9 flashes = reserved for future use
10 flashes = main power interrupt
example: flash-flash-pause-flash-flash-pause = shock sensor
Silent Arming/Disarming
The Galaxy 5000RS Plus system can be programmed to operate the system without Arm and Disarm chirp
indications. When programmed for full-time silent operation, the siren will sound only when the system is
triggered.
The system is also capable of temporary silent operation if desired. Pressing the Shift button before Arming
or Disarming the system will bypass the chirp confirmations and allow one-time silent operation.
Note: The open zone warning chirps will not be bypassed when the system is Armed or Disarmed silently.
Passive Arming
When programmed for the optional Passive Arming feature, the system arms itself automatically, each time
the ignition is turned off and all of the doors, hood, and trunk are closed.
To start the Passive Arming Process:
1. Turn off the ignition.*
2. Open the door and exit the vehicle.
· Once all doors are closed and the dome light is off, the LED will begin flashing rapidly.
· The parking lights will flash twice indicating the Passive Arming sequence has begun.
3. After 30 seconds,
· The siren will chirp.
· The parking lights will flash.
· The doors will lock.**
· The status LED will begin flashing.
4. The system is now armed.
* The ignition must have been on for
at least
5 seconds or the Passive Arming sequence will be disabled.
** If the Passive Locking feature is selected.
To temporarily disable Passive Arming, turn on the ignition then turn off within 5 seconds. The siren will
chip once indicating the system will not passively arm until the ignition is cycled again.
The system can be programmed to provide an Entry Delay when the system is armed passively. Upon
opening the door the siren will chirp for 10 seconds allowing time to enter the vehicle and turn on the
ignition before the full siren output is triggered.