Filter
Top Products
16
8. Plug #2 (Figure 6) comes off the new
wire harness and attaches to the
ballast, and plug #5 (Figure 8) comes
off the headlamp and attaches to the
ballast. Both passenger and driver
sides are the same.
9. Plug #3 (Figure 7) comes from the
wire harness and plug #4 (Figure 8)
comes from the back of the
headlamp. These two are attached on
both the driver and passenger sides.
10. Plug #1 (Figure 7) comes from the
new wire harness and attaches to the
stock connector that was attached to
the original headlamp. This is only
on the drives side. The plug that
attached to the stock headlamp is
extra and needs to be capped off.
11. Zip-tie the new harness to the stock
harness. Follow each curve. Make
sure to cut all zip ties flush to the
fastening side.
12. The stock plug that attacked to the
passenger’s headlamp will not be
used. It needs to be capped off.
Figure 7
5 2
1
Figure 6
Figure 8
2 3
4 5