Filter
Top Products
62 9-3 Convertible
8 Sit in one of the front seats and lock the
soft top to the windshield rail. Use the lug
wrench and the Allen key. Turn roughly
1/4 turn anticlockwise. Check that the
soft top is properly locked in place by
pressing up the front edge. The soft top
must not move upward.
9 Lift up the rear window fully and hold it
there. Close the soft top cover. It is not
possible to lock the soft top cover after
manual raising.
10 Press down the rear edge of the soft top
as far as possible towards the soft top
cover.
11 Now lock the rear window to the soft top
cover. Sit in the rear seat and insert the
tool (the same tool as used to lock the
soft top to the windshield rail) into the
hexagonal hole in the soft top mecha-
nism. Turn roughly 1/4 turn, anticlock-
wise on the right had side of the soft top
and clockwise on the left-hand side.
Look at the soft top cover when locking
the rear window. The rear window must
make a tight seal against the soft top
cover.
The soft top system must be checked and
rectified without delay at a Saab dealer.
NOTICE
To avoid damaging the paintwork on the
soft top cover and the trunk lid, take care
when closing the soft top cover.
Closing the soft top cover Rear window locked to soft top coverSoft top locked to windshield rail