Filter
Top Products
11
HOSE
R
I
OPERATION
TO INSTALL BATTERY PACK
See Figures 3 - 4.
Place the power switch in the OFF ( O ) position.
Place the battery pack in the canister vac.
Make sure the latches on each side of the battery pack
snap in place and that battery pack is secured in the
canister vac before beginning operation.
TO REMOVE BATTERY PACK
See Figures 3 - 4.
� Place the power switch in the OFF ( O ) position.
Locate latches on side of battery pack and depress both
sides to release battery pack.
� Remove battery pack from the canister vac.
WARNING:
Battery tools are always in operating condition. Therefore,
switch should always be in the OFF ( O ) position when
not in use or carrying at your side.
HOSE ATTACHMENT
See Figure 5.
To attach the hose, push tapered end of hose into
opening of the vacuum port.
To remove the hose, hold the tapered end and pull hose
from vacuum port.
USING THE ATTACHMENTS
See Figure 6.
Vacuuming can be performed with either the hose or the
vacuum attachments.
Turn off the canister vac.
Insert the attachment into the front end of the hose,
making sure the attachment is firmly in place.
To remove, hold the attachment and pull from hose.
The vacuum attachments are designed for the following
applications:
The wide nozzle with squeegee is used to vacuum large,
flat, dry or wet surfaces.
The floor brush is used to vacuum carpeted surfaces.
The wand is used as a handle in vac mode and as a blower
tube in blower mode. The wand can also function as an
extension to any of the canister vac attachments.
The car nozzle is used for car interiors or for vacuuming
small surface areas. The car nozzle can also be used with the
wand while the canister vac is in blower mode for widened
air flow.
The narrow crevice tool is used to vacuum narrow, hard
to reach places.
POWER
SWITCH
( I )
ON
( O )
OFF
Fig. 6
VACUUM
PORT
Fig. 5
WAND
WIDE NOZZLE
WITH SQUEEGEE
FLOOR
BRUSH
NARROW
CREVICE TOOL
CAR
NOZZLE
Fig. 4