Filter
Top Products
English 3
Before you use RTG-2000, the battery must be charged for at least six
hours. Plug car charger into power jack and cigar-lighter separately. As
RTG-2000 is in charging, the Yellow LED will be lighted up. When the
battery is fully charged, the Yellow LED will be turned off. Unplug car
charger from power jack and cigar-lighter separately.
STEP 2: Turn on Receiver and wait for GPS fix
If the position has not been fixed yet, the Green LED will be blinking.
STEP 3: Connect to Bluetooth-enabled handheld device
From your Bluetooth-enabled handheld device, execute Bluetooth
application software to search RTG-2000 and then connect it to your device.
If the connection between your device and RTG-2000 is not successful, the
Blue LED will be blinking.
New→Connect
STEP 4: Connect to your Navigation Software
Install and launch your navigation software in Navigation Software Kit and
set GPS configuration. Select correct COM port subject to the outbound
Bluetooth serial port of your handheld device and correct baud rate
depending on your navigation software.
•If you are required to type in pin code during configuration, please key in
Explore a Bluetooth
device
Tap Bluetooth GPS
BlueGPSxxxxxx
Select Serial Port
Successful
Tap BlueGPS→
Connect
Click Finish