Filter
Top Products
DYNAMIXEL
RX-28
The returned Status Packet is as the following
Status Packet : 0XFF 0XFF 0X00 0X02 0X00 0XFD
ID LENGTH ERROR CHECKSUM
Note the ID of this Dynamixel actuator is now changed to 1 after the RESET instruction.
4-6. SYNC WRITE
Function
Used for controlling many Dynamixel actuators at the same time. The communication
time decreases by the Synch Write instruction since many instructions can be
transmitted by a single instruction. However, you can use this instruction only when the
lengths and addresses of the control table to be written to are the same. Also, the
broadcasting ID needs to be used for transmitting.
ID
0XFE
Length
(L + 1) * N + 4 (L: Data length for each Dynamixel actuator, N: The number of Dynamixel
actuators)
Instruction 0X83
Parameter1
Starting address of the location where the data is to be written
Parameter2 The length of the data to be written (L)
Parameter3 The ID of the 1st Dynamixel actuator
Parameter4 The 1st data for the 1st Dynamixel actuator
Parameter5 The 2nd data for the 1st Dynamixel actuator
Data for the 1st Dynamixel actuator
…
Parameter L+3 The Lth data for the 1st Dynamixel actuator
Parameter L+4
The ID of the 2nd Dynamixel actuator
Parameter L+5 The 1st data for the 2nd Dynamixel actuator
Data for the 2nd Dynamixel actuator
Parameter L+6
The 2nd data for the 2nd Dynamixel actuator
…
Parameter 2L+4 The Lth data for the 2nd Dynamixel actuator
….
Example 5 Setting the following positions and velocities for 4 Dynamixel actuators
Dynamixel actuator with an ID of 0: to position 0X010 with a speed of 0X150
Dynamixel actuator with an ID of 1: to position 0X220 with a speed of 0X360
23