Filter
Top Products
GPS READY MOUNT SPEAKER FUNCTION
7
Speak Function (For GPS Ready Mount with speaker only)
The speaker function enables users to listen to GPS voice commands, digital books, and MP3 music over
the noise of the road through the built-in high performance speaker.
Step 1: Slide your PDA in the cradle.
Step 2: Plug the cigarette lighter connector from the cradle to the cigarette lighter
port in your car to get power from the car to operate the G2500 Mount.
Step 3: Connect the audio cable from the headphone jack on the PDA and to the
speaker jack on the cradle, which is located on the top right corner of the cradle.
Step 4: Play your music or any other voice program on your PDA. The sound
playing on your PDA will now play from the built in speaker on the cradle.
Step 5: Adjust the volume level by using the volume control on the left side of the
cradle to your desired volume level.
Make sure the volume level will not disturb you when you are driving
.
Audio Cable
GPS READY MOUNT ADDITIONAL POWER OUTPUT
8
Charge an additional Device using add-on Charging Cable
This add-on charging cable must be purchased separately
With an Add-on Charging cable (optional), the GPS Ready Mount can charge an additional PDA, wireless
phone or some of the digital device such as FM transmitter.
To use this cable, plug the one end of the cable into the DC OUT port located on the left side of the cradle.
Plug the other end of the cable into the device charging port.