Filter
Top Products
SiRF LP, HS Bluetooth GPS GPS-6031-X7 Operating Manual Rikaline
Rikaline International Corp. 10F, 64, Kang-Ding Road, Taipei 108, Taiwan
Tel: ++886 2 2370 4688 Fax: ++886 2 2370 4686 E-Mail: info@rikaline.com.tw Web: www.rikaline.com.tw
3
0. Quick Use for First Time Setting
After you have received your Rikaline GPS-6031-X7 Bluetooth GPS Receiver, please do the following steps
before using the device.
0.1 Fully charge the battery for at least 10 hours before using.
A fully charged battery can last for 11 days (275hours) using a low power consumption scheme at 6mA standby
mode. Please remove the battery if the device will not be in use for an extended period of time.
0.2 Activate the Bluetooth function in your PDA or PC
Before activating Bluetooth function in your PDA/PC for pairing the Receiver, please press Receiver’s button for
5 seconds. The pairing code is “1234”. Please check your device is equipped with Bluetooth function. If not, you
may need to acquire an optional CF (PD-3005) or SD Bluetooth card.
NOTE: The pairing procedure is required to execute in the first time.
0.3 Automatically create a shortcut in Bluetooth Manager window
After you complete the pairing, system will automatically create a quick connect device in Bluetooth Manager.
In further use, you just need to click this device to connect our Bluetooth Receiver.
0.4 Check the Serial Port in Bluetooth Setting
After completing pairing with the Receiver, please click “Serial Port” to confirm the COM port. If you use
PDA/PC to pair the Receiver, please select “Outbound COM port”; otherwise, if you use the Receiver to pair
PDA/PC, please select “Inbound COM port”.
0.5 Set correct Serial Port in your Map software.
Activate your map function and select the correct serial port by following above C instruction.
0.6 Switch off the Bluetooth function
Switch off the Bluetooth function before you turn off your PDA/PC, and Receiver will disconnect the GPS
function automatically.
0.7 Turn off your PDA or PC
0.8 Advanced Function
GPS-6031-X7 also provides user an advanced active paring function. Before using this advanced function,
you have to click “Serial Port” in Bluetooth setting window in your PDA/PC, and then mark “Authorization
required” and “Authorization passkey required”. Press the Receiver’s button for 1 second, then select “Accept”
or “Reject” in your PDA/PC to do the linking.
NOTE: The advanced function is not suitable for first time use
.
0.9 Appendix
LED Indicator
4 LED functions as follows (from the left side):
1. External Power-Red: On: Available Off: Not Available
2. Bluetooth-Blue: On: Pairing / In Transmitting Mode
3. GPS-Green: On: GPS powered Off: GPS not powered
4. Battery-Red: Flash: Low Power On: Recharging Off: Sufficient Power