Filter
Top Products
8
REPAIR AND MAINTENANCE
q Replacing the Fuse – MX350 / MX500 / MX650
WARNING:
To prevent shock or short circuit,
please follow the instructions
accordingly and do not skip or
combine any steps.
1 Remove the fairing/body
cover.
2 Locate the fuse cover
attached to the batteries.
3 Open the fuse cover to
expose the fuse.
4 Remove the fuse and replace
with a new one of equal
amperage.
Note: Amperage is located
on top of fuse and should be
replaced with equal amperage.
5 Close the fuse cover and
reattach the fairing/body cover.
Amperage
number
qChecking Spoke Tension – MX500 / MX650
WARNING:
Regularly check the spoke
tension and retighten the
spokes whenever loose. If
you have any doubt, ask an
experienced motorcycle or
bicycle mechanic to inspect
your spokes to determine if
the spokes need tightening or
adjusting.
1 Verify spoke tension by grasping and shaking each spoke. Spoke
should not be loose from hub. Look for any play between spoke flang-
es where it mates with hub. Try to turn nipple using your fingers. You
should not be able to spin any nipple by hand. If one or more spokes
are loose, or if you can turn any nipple using your fingers, all spokes
must be checked and need to be tightened with a spoke wrench.
Spoke
Flange
Spoke
Nipple
Hub
Flange
Spoke
Flange
Rim
Nipple
2 Start with spoke closest to
tire valve stem and tighten each
nipple, in sequence, exactly 1⁄4
to 1⁄2 turn. A single 1⁄4 to 1⁄2
turn may not be enough to bring
the spokes into proper tension.
Continue tightening all spokes
no more than 1⁄2 turn in
sequence until all spokes
are tight.
Note: Tightening each nipple
more than a 1⁄2 turn each can
cause the wheel to become
distorted and wobbly thus
permanently damaging the
wheel.
1
2
3
4
28
27