Filter
Top Products
17
Muting the Audio Alert
While the detector sounds a radar or safety alert signal,
you can press
MUTE
to temporarily silence the detector.
When you press
MUTE
, the voice alert says, “mute on.”
The detector automatically resets the mute to off about
20 seconds after the radar or safety alert signal stops. Or,
you can simply press
MUTE
again before it resets, and
the voice alert says, “mute off.”
Note
: Laser alert signals are not affected by pressing
MUTE
.
Selecting VG-2 Mode
VG-2 mode is pre-set to off. To turn on VG-2, hold down
MUTE
until the voice alarm says, “VG-2 on.” To turn VG-2
off, hold down
MUTE
until the voice alarm says, “VG-2
off.”
22-1692.FM Page 17 Wednesday, September 11, 2002 8:35 AM