Filter
Top Products
G438.696
© 1994, 1995 Directed Electronics, Inc. 7 95G438.PM5
Panic Mode
If you are threatened in or near your vehicle, you can attract attention by
triggering the system with your transmitter! Just press button I for 1.5 seconds,
and you will enter Panic Mode. The siren will sound and the parking lights will
flash for 30 seconds. To stop Panic Mode at any time, press button I on the
transmitter again.
Valet
®
Mode
You can prevent your system from automatically arming and triggering by
using Valet
®
Mode. This is very useful when washing the vehicle or having it
serviced. In Valet
®
Mode, the system will not arm, even with the transmitter,
but all convenience functions (door locks, trunk release, etc.) will work
normally.
To enter or exit Valet
®
Mode with the Valet
®
switch:
Turn ignition to "run" position, then turn to "off" position.
Press and release the Valet
®
switch within 10 seconds.
The Status LED will light steady if you have entered Valet
®
Mode, and
it will go out if you exited Valet
®
Mode.
Using Remote Valet
®
as you enter or exit the vehicle:
Open any door.
Press button I (or the arm/disarm button).
Press button II (or the channel 2 button).
Press button I again.
The Status LED will light steady if you have entered Valet
®
Mode,
and it will go out if you exited Valet
®
Mode.
G438.696
© 1994, 1995 Directed Electronics, Inc. 10 95G438.PM5
Code Hopping
™
E
XPLAINED
The receiver and transmitters each use a mathematical formula called an
algorithm to change their code each time the transmitter is used. This technol-
ogy has been developed to increase the security of the unit. The control unit
knows what the next codes should be. This helps to keep the transmitter “in
synch” with the control unit even if you use the remote control out of range of
the vehicle. However, if the transmitter has been pressed many times out of
range of the vehicle, or the battery has been removed, it may get out of synch
with the control unit and fail to operate the system. To re-synch the remote
control simply press the arm/disarm button of the remote control several times
within range of the vehicle. The alarm will automatically re-synch and respond
to the transmitters normally.
High Frequency
Your system transmits and receives at 434 MHz. This provides a cleaner
spectrum with less interference and a more stable signal. Enjoy a phenomenal
increase in range - even in areas with high radio interference.
Programming Options
Programming options control what your system does during normal operation,
and require little or no additional parts. However, some may require additional
installation labor.
The following is a list of the programmable options, with the factory settings in
Bold.
•
Active arming (only with the transmitter) or passive arming (automatic
arming 30 seconds after the last door has been closed).
•
Arming/disarming confirmation siren chirps on or off.
•
Passive door locking (with passive arming) or active door locking (only
when arming with the transmitter) . This feature only works if passive
arming has been selected for step one.
•
The ignition-controlled door locking feature on or off. With this feature on,
the doors will lock 3 seconds after the key is turned on, and unlock when