Filter
Top Products
30
© 2006 directed electronics—all rights reserved
To perform Valet Take-Over:
1. Before turning off the engine, press and release on the
transmitter twice within 3 seconds. Then wait five seconds.
2. Turn the ignition key to the OFF position. (The engine will
stay running.)
3. The engine will run until the pre-programmed time elapses
or a shut-down input is received. (See the previous Remote
Start section for a complete list of shut-down inputs.)
short-run/turbo
Short run turbo mode keeps the engine running after arriving at
you destination for a programmable period of 1, 3, 5 or 10
minutes. This allows the system’s timer to conveniently cool
down the turbo after you have left the vehicle.
To activate:
1. Park the vehicle and set parking brake.
2. Remove your foot from the brake pedal and leave the
engine running.
3. Press and release the and buttons at the same
time.
4. The lights will flash to indicate the remote start has entered
short run turbo mode.
➜
note: This feature will not work if the brake pedal is
being pressed.