Filter
Top Products
2. Remove Console
.a. Lift out ash trays. remove 2 -7 mm screws from each (under ash trays).
Note: This part of the console only needs to be lifted a few inches. Do not pullover gear lever.
b. Loosen 2 -7 mm screws at the front of main console. Open glove box, remove 2 -7 mm screws. Lift out
console.
Note: Use caution upon removal not to damage wiring that is attached to the cigarette lighter.
Glove Box
Loosen two
7 mm Screws
./
?~
Removetwo
7 mm .Screws ~
.,
~
~--"-~--~-:~:
Fig. 5
Ash Tray, one on each
side of gear lever
Remove two 7 mm Screws
Harness
Extension
Connect white connector to 16' extension,
use red self-stripping connectors:
3