Filter
Top Products
97
MAINTENANCE
Battery
Battery Installation
WARNING! Battery electrolyte contains acid. Avoid skin contact with electrolyte
as severe burns may result.
Using a new battery that has not been fully charged can damage the bat-
tery and result in a shorter life. It can also hinder vehicle performance.
1. Ensure that the battery is fully charged.
2. Place the battery in the battery holder. Attach the hold down strap.
3. Install the battery vent tube. The vent tube must be free of obstruc-
tions and securely installed. Route the vent tube properly to prevent
kinks and to allow for proper drainage.
WARNING! Battery gases could accumulate in an improperly installed vent tube
and cause an explosion, resulting in serious injury or death. Always ensure that
the vent tube is free of obstructions and is securely installed as recommended.
Whenever removing or installing the battery, disconnect the negative (black)
cable first and reinstall the negative cable last to avoid the possibility of
explosion.
4. Coat the terminals with dielectric grease or petroleum jelly.
5. Connect and tighten the red (positive) cable first.
6. Connect and tighten the black (negative) cable last.
7. Verify that cables and vent tube are properly routed.