Filter
Top Products
100
MAINTENANCE
General Maintenance
Bleeding the Cooling System
Use of a non-standard pressure cap will not allow the recovery system to
function properly. If the pressure cap needs replacement, contact your
dealer for the correct part.
Recovery System (WideTrak)
If the coolant level becomes low in the coolant
bottle, bleed the system of any trapped air.
Visually inspect the coolant filter (✪) and
replace it if it's dirty.
1. Fill the coolant bottle with coolant to the
maximum mark.
2. Elevate the front end of the machine
slightly to aid bleeding of the heat exchangers.
3. Remove the pressure cap and add coolant to the top of the filler
neck.
4. Install the pressure cap with the lever lock up, in its release position.
5. Run the engine at various RPMs for two to three minutes to purge
the system of trapped air.
6. Close the lever lock and check the coolant bottle fluid level. Add
coolant if necessary to the maximum mark.
WARNING
Steam and hot liquids will cause serious burns to your skin. Never bleed the
cooling system or remove the pressure cap when the engine is warm or hot.
✪