Filter
Top Products
108
MAINTENANCE
Battery
Battery Installation
1. Ensure that the battery is fully charged.
2. Place the battery in the battery holder.
3. With conventional batteries, install the battery vent tube (sealed bat-
teries do not have a vent tube). The vent tube must be free of
obstructions and securely installed. Route the tube away from the
frame and vehicle body to prevent contact with electrolyte.
4. On conventional batteries, coat the terminals with dielectric grease
or petroleum jelly.
5. Connect and tighten the red (positive) cable first. Connect and
tighten the black (negative) cable last.
6. Install the battery cover (if equipped). Secure the battery hold-down
strap.
7. Verify that cables are properly routed. Cables should be safely
tucked away at the front and rear of the battery.
Battery Storage
Whenever the vehicle is not used for a period of three months or more,
remove the battery from the vehicle, ensure that it's fully charged, and
store it out of the sun in a cool, dry place. Check battery voltage each
month during storage and recharge as needed to maintain a full charge.
Polaris recommends maintaining battery charge by using a Polaris Bat-
tery Tender charger or by charging about once a month to make up for
normal self-discharge. Battery Tender can be left connected during the
storage period, and will automatically charge the battery if the voltage
drops below a pre-determined point. See page 120 for the part numbers
of Polaris products.
WARNING
Battery gases could accumulate in an improperly installed vent tube and
cause an explosion, resulting in serious injury or death. Always ensure that
the vent tube is free of obstructions and is securely installed as
recommended.