Filter
Top Products
108
MAINTENANCE AND LUBRICATION
Oil Pump Priming
This priming procedure must be
performed whenever the oil hose
connection between the oil tank and
pump inlet has been disconnected.
1. Clamp or pinch off the vent
line (1) approximately 2I
(5 cm) from the oil tank.
2. Run the engine for 5-10
seconds at idle. Stop t he
engine and remove the vent
line clamp. If the line is bled
properly, you should hear a rush of air, indicating that the line is properly primed and
ready for operation. If you do not hear air, the line has not bled, and you’ll need to
repeat the priming procedure.
2I
1