Filter
Top Products
132
MAINTENANCE AND LUBRICATION
Battery
The sealed battery is already filled with electrolyte and has been sealed and fully charged at
the factory. Never pry the sealing strip off or add any other fluid to this battery.
Keep battery terminals and connections free of c orrosion. If cleaning is necessary, remove
the corrosion with a stiff wire brush. Wash with a solution of one tablespoon baking soda
and one cup water. Rinse well with tap water and dry off with clean shop towels. Coat the
terminals with dielectric grease or petroleum jelly.
WARNING
Improperly connecting or disconnecting battery cables can result in an explosion and
cause serious injury or death. When removing a battery, a lways disconnect the
negative (black) cable first. When reinstalling the battery, always connect the
negative cable last.
Battery Removal
1. Remove the rear cab (see page 121) and disconnect the strap securing the battery.
2. Disconnect the black (negative) cable first, then disconnect the red (positive) cable.
3. Lift the battery out of the ATV.