Polaris 800 PRO RMK Offroad Vehicle User Manual


 
67
OPERATION
Break-In Period
Drive Belt/QUICKDRIVE Belt Break-In
The length of the break-in period varies depending on the type of drive
system. The break-in period for a new drive belt is 30 miles (48 km).
The break-in period for a new QUICKDRIVE belt is 100 miles (160
km).
Vary the throttle position and limit full throttle use.
Always take time to warm up the belt and driveline prior to operating
the snowmobile. Free the track and skis from the ground before
engaging throttle.
Break-In Requirements Specific to the QUICKDRIVE Belt
During the 100 miles (160 km) of belt break-in, the rider will hear a
sound made by the drive system. After the break-in period, the sound
will become similar to that of a traditional chaincase.
Improper track tension can result in track ratcheting, which will affect
QUICKDRIVE belt durability. Always maintain proper track tension.
See page 104.
During the break-in period, this belt sheds a fiber-type material in and
around the drive system. Use a dry shop towel to clean the residue.
Stop occasionally and allow the snowmobile to cool after high
throttle/high track load events. This will help the QUICKDRIVE belt
achieve maximum performance and it will also break in the engine,
drive belt and sprockets properly.
On-trail break-in should be performed at speeds no more than 50
MPH (80 km/h).
Always be cautious when jumping and landing a snowmobile. Avoid
“power-on” landings. Damage caused to any component due to
improper use or abuse is not covered by warranty.