Polaris 800 INDY Offroad Vehicle User Manual


 
69
THE PERFECT FIT
Left Hand Control Alignment
1. Loosen the four control block mounting screws.
CAUTION! Take care to avoid damaging hand warmer/brake switch wires
when moving components.
2. Move the control block to the
desired position.
NOTE: If the control is loose and was
inadvertently moved without
loosening the screws, move the
control block slightly to the left or
right to relocate the pins.
3. Tighten the screws to specification
in the sequence shown in the image.
Do not over-torque.
Torque: 24 in-lbs (2.7 Nm)
Throttle Block Alignment
1. Slightly loosen the set screw on the
bottom of the housing.
2. Move the control block to the
desired position.
NOTICE: Take care to avoid damaging hand
warmer wires when moving
components.
3. Tighten the screw to specification.
Do not over-torque.
Torque: 27 in-lbs (3 Nm)
4. With the engine off, test throttle lever movement after tightening the
screw. See page 86.
Engine Stop Switch Alignment
1. Slightly loosen the set screw on
the bottom of the housing.
2. Move the switch to the desired
position.
CAUTION! The stop switch must be
positioned in an easily accessible location.
3. Tighten the screw to specification.
Do not over-torque.
Torque: 12 in-lbs (1.4 Nm)
1
2
3
4
Control Block
Throttle Block
Set Screw
Stop Switch
Set Screw