Polaris 800 Dragon RMK 155/163 Offroad Vehicle User Manual


 
114
TROUBLESHOOTING
Suspension Troubleshooting
Problem Solution
Rear suspension bot-
toms too easily
Set static sag (see page 43). Adjust torsion spring blocks or
install optional torsion springs to achieve correct sag
dimensions.
Rides too stiff in rear Check for binding suspension components and grease all
pivot points.
Set static sag (see page 43). Adjust torsion spring blocks or
install optional torsion springs to achieve correct sag
dimensions.
Too much weight
transfer when climb-
ing
Set static sag (see page 43). Adjust torsion spring blocks or
install optional torsion springs to achieve correct sag.
Move limiter strap to high position (see page 44).
Too little weight
transfer when climb-
ing
Set static sag (see page 43). Adjust torsion spring blocks or
install optional torsion springs to achieve correct sag.
Move limiter strap to low position (see page 44).
Front end pushes Check for worn skags.
Check for binding front suspension shafts/steering compo-
nents, grease all pivot points (elevate front of machine).
Set static sag (see page 43). Adjust torsion spring blocks or
install optional torsion springs to achieve correct sag.
Increase IFS preload (if equipped).
Move limiter strap to high position (see page 44).
Steering is heavy Make sure spindles and all steering components turn freely.
Check ski alignment (see page 104).
Check skags and skis for damage.
Set static sag (see page 43).
Machine darts from
side to side
Check ski alignment (see page 104).
Check for binding front suspension shafts/steering compo-
nents, grease all pivot points (elevate front of machine).
Check for excessive play in steering assembly (see dealer).
Ensure skags are straight on skis.
Set static sag (see page 43).
Check rail slide/replace if worn (see page 106).
Install Accu-Trak dual skags (see your dealer).