Filter
Top Products
A
105
MAINTENANCE
Steering System
n
Ski Skags
WARNING
Worn skis and/or skags will adversely affect handling. Loss of
vehicle control may result, causing serious injury or death.
See your dealer’s studding chart for recommended skags. If you
install longer or more aggressive carbide skags than the original
equipment, it may also be necessary to add track studs to
maintain proper vehicle control while turning on hard-packed
snow or ice.
Check skags before each use of the snowmobile to ensure positive
steering characteristics. Skags must be replaced when worn to half their
original diameter.
NOTE: Carbide skags must be replaced if any abnormal wear or
chipping is found.
Skag Replacement
1. Raise and support the front of
the machine so the skis are
approximately 6″ (15.2 cm)
from the ground.
2. Remove the attaching nuts
andprytheskag(A)
downward.
3. Remove the front end of the skag.
4. Remove the rear end of the skag.
5. Reverse the steps to install a skag.