Polaris 600 RMK Offroad Vehicle User Manual


 
92
MAINTENANCE
Brakes
Hydraulic Brake Inspection
Inspect the brake lever reserve before each use of the snowmobile. See
page 57.
Brake pads must be replaced when the brake pad material becomes thin-
ner than the backing plate (approximately 1/16I). A kit is available for
replacing brake pads. See your dealer.
WARNING! Brake failure during operation can result in serious injury or death.
Properly functioning brakes are vital to your safety. Be sure the brake pads do
not drag on the disc and that brake lever travel is not excessive. Always replace
brake pads when the brake pad material becomes thinner than the backing plate
(approximately 1/16
I).
Brake Components
1. Brake Caliper
2. Brake Disc
3. Brake Pad Material (Replace
when thickness is less than 1/
16I/1.5 mm).
4. Anti-rattle springs (come
with brake pad kit)
Excessive Lever Travel
Hydraulic brakes are self-adjust-
ing, but if excessive brake pad
clearance develops, bring the
snowmobile to an authorized
POLARIS dealer for inspection
and adjustment.
TIP:The PRO RMK and RMK ASSAULT models are equipped with a lightweight
brake disc that has vent holes. These holes may cause a high-pitched
sound during operation.
2
1
3
4