Polaris 600 RMK 155 Offroad Vehicle User Manual


 
59
OPERATION
Track Warm-Up
WARNING! A loose track or flying debris could cause serious injury or death.
Stand clear of the front of the machine and the moving track. Never hold the
snowmobile up or stand behind it while warming up the track. Do not use
excessive throttle during warm-up or when the track is free-hanging. Be sure the
rear support is stable.
WARNING! Use of traction products such as studs, ice growsers, etc. will
increase the possibility of track damage and/or failure. This could cause loss of
control, resulting in serious injury or death. Always inspect for track damage
before operating the snowmobile.
Follow these steps to ensure proper warm-up
of the engine, drive train and track.
1. Use an appropriate stand to securely
support the rear of the snowmobile at the
rear bumper. The track should be
approximately 4" (10 cm) off the
ground.
2. Start the engine and allow it to warm up
two to three minutes.
3. Depress the throttle abruptly and allow
the track to rotate several revolutions.
TIP:It will take longer to warm up the track sufficiently during colder outdoor
temperatures.
4. Release the throttle, apply the brakes, shut off the engine and lower
the snowmobile to the ground.
5. Grasp the skis by their front loops and move them from side to side
to loosen snow and ice.