Filter
Top Products
44
FEATURES
Instrumentation
MFD Digital Display Programs
Engine Program
Altitude (if equipped)
The rider can calibrate the altimeter for current
atmospheric conditions. Altimeter accuracy
will be +/-300 ft. (91 m) after adjustment.
1. Enter the Engine Program.
Tip: Press and hold the MODE switch for ten sec-
onds to switch between standard and metric
units of measurement. When "ALt" displays, the
program is in the metric mode.
2. Press and release the SET button until the altimeter screen is active.
3. Press and hold the SET button for five seconds. When the digits
begin to flash, release the button.
4. Press and release the SET button once to advance 50 feet (15 m).
Tip: Press and hold the SET button to advance quickly by 100-foot (30 m) incre-
ments.
5. Adjust the altitude display to within 50 ft. (15 m) of current altitude.
Tip: The gauge reads barometric pressure and allows the rider to compensate
for daily fluctuations in air pressure. The gauge can adjust the displayed
altitude to +/- 1300 ft. (396 m) from the preset value. It will adjust up to
+1300 ft. (396 m) above the calibrated altitude. Once the +1300 ft. (396 m)
offset has been reached, the next adjustment is -1300 ft. (396 m) from the
calibrated altitude, and 50 ft. (15 m) will be added to the altitude each time
the SET button is pressed.
6. Press and release the MODE button to set the reading at the adjusted
value. If the MODE button is not pressed within ten seconds, the
gauge will automatically save the new entry.