Filter
Top Products
35
FEATURES AND CONTROLS
Instrument Cluster
Rider Information Center
Information Display Area
Use the SELECT button (SEL) to toggle through the information area
options. SELECT button operation is locked out at speeds above
approximately 15 MPH (25 km/h).
Tip: The reverse override switch also acts as the SELECT button when pressed
and released quickly. The transmission cannot be in reverse when using the
override switch as a SELECT button. This feature does not contain a vehi-
cle speed lockout function and can be used at any operating speed.
Standard/Metric Display
The display can be viewed in either standard or metric units of measure-
ment. To change units:
1. Press and hold the MODE button until vehicle speed is displayed.
2. Toggle through the information area using the SELECT button until
the odometer is displayed.
3. Press and hold the MODE button until the displayed units change.
Release the button.
4. New settings remain until changed using the same procedure.
12-Hour/24-Hour Clock Display
1. Press and hold the MODE button until RPM is displayed.
2. Toggle through the information area using the SELECT button until
the odometer is displayed.
3. Press and hold the MODE button until the clock displays the new
clock format (either 24-hour or 12-hour). Release the button.
4. New settings remain until changed using the same procedure.
Odometer Mode
The odometer records and displays the distance traveled by the vehicle.
Trip Meter Mode
The trip meters record the distance traveled by the vehicle on each trip if
reset before each trip. To reset a trip meter, select the trip meter 1 or trip
meter 2 mode. Press and hold the MODE button on the instrument clus-
ter until the total changes to 0. In the Rider Information Center, the trip
meter display contains a decimal point, but the odometer displays with-
out a decimal point.
Hour Meter Mode
This mode logs the total hours the engine has been in operation.