Filter
Top Products
70
ADULT SECTION
Maintenance
Handlebar Adjustment
1. Slide the handlebar pad
upward to access the
adjuster bolts. If additional
room is required, unzip one
of the handlebar pad zippers
and roll the pad to the side.
2. Remove the upper flange
nut and carriage bolt.
3. Loosen the lower flange nut
only enough so the bracket
can move freely.
4. Position the handlebar to
the desired height.
5. Reinstall the upper carriage
bolt and flange nut.
6. Torque both flange nuts to 15-17 ft. lbs. (20-23 Nm).
7. Reinstall the handlebar pad.
Lower
Nut
Upper Bolt