Pioneer AVIC-8000NEX GPS Receiver User Manual


 
Black plate (25,1)
! The cords must not cover the area shown
in the figure below. This is necessary to
allow the amps and navigation mechanism
to dissipate heat.
Do not cover this area.
! The semiconductor laser will be damaged
if it overheats, so dont install this product
anywhere hot for instance, near a heater
outlet.
Parts supplied
Parts marked (*) are supplied with AVIC-6000-
NEX, AVIC-5000NEX and AVIC-X8610BS.
This product Truss head screw
(5 mm × 8 mm)
(6pcs.)
Flush surface screw
(5 mm × 9 mm)
(6pcs.)
Screw*
(2mm × 4mm)
(1pc.)
Installation using the screw
holes on the side of this product
% Fastening this product to the factory
radio-mounting bracket.
Position this product so that its screw holes
are aligned with the screw holes of the brack-
et, and tighten the screws at three locations
on each side.
Use either the truss head screws (5 mm ×
8 mm) or flush surface screws (5mm ×
9 mm), depending on the shape of the brack-
ets screw holes.
If the pawl interferes with installation,
you may bend it down out of the way.
1
2
3
1 Factory radio-mounting bracket
2 Dashboard or console
3 Truss head screw or flush surface screw
Be sure to use the screws supplied with
this product.
<CRD4769-A>25
En
25
English
Section
03
Installation