Pioneer AVIC-N3 GPS Receiver User Manual


 
27
Installation
Parts supplied
When installing the antenna inside the vehicle (on the rear shelf)
Affix the metal sheet on as level a surface as possible where the GPS antenna faces the
window. Place the GPS antenna on the metal sheet. (The GPS antenna is fastened with its
magnet.)
Note:
When attaching the metal sheet, do not cut it into small pieces.
Some models use window glass that does not allow signals from GPS satellites to pass through. On
such models, install the GPS antenna on the outside of the vehicle.
Metal Sheet
Peel off the protective sheet
on the rear.
GPS antenna
Make sure the surface is
free of moisture, dust,
grime, oil, etc., before
affixing the metal sheet.
Note:The metal sheet
contains a strong adhesive
which may leave a mark on
the surface if it is removed.
Clamps
Use clamps to secure the
lead where necessaryinside
the vehicle.
Waterproof padClamp (5 pcs.)Metal sheetGPS antenna
ENG/MASTER 96
<CRD4069A/U> 28
CRD4069-A_U_inst_001_031_US 10/25/05 10:58 Page 28