Filter
Top Products
11
English
12
English
5 ADJUSTING THE RECLINING ANGLE
Press
and to adjust the angle of the backrest and legrest.
With the button held down, movement will continue until a “beep-beep-beep” sound indicates the backrest has been raised or
lowered as far as possible.
The legrest will start to move shortly after the backrest.
Approx. 75˚
Approx. 0˚
Approx. 120˚
Approx. 170˚
* The reclining operation is a function that adjusts the angle of the backrest and legrest. Avoid using it for any other purposes,
such as continuous up/down operation etc.
6 ADJUSTING THE LEGREST LENGTH
Push the legrest out by pulling back on the legrest slide lever.
Pull the legrest slide lever.
Push with the soles
of your feet to slide
the legrest out.
Raise the legs slightly
and the legrest returns.
•
•
Pre-Program and Quick Massage Characteristics
Shiatsu
Uses mainly Soft Shiatsu,
Tap and Knead actions to
comfortably loosen and
provide relief from tension
held at pressure points.
Recommended
for those
with severe stiffness or
who prefer a stimulating
massage.
Swedish
Uses mainly Swedish,
Hawaiian and Knead actions
to evenly apply muscle-
relaxing strokes all over.
Recommended
for those
who want a gentle relaxing
massage.
Chiro
Uses Full Roll and
Compression to stretch all
your muscles. A kneading
action is applied to a stiff
back and joints to refresh the
posture and strengthen you
against fatigue.
Recommended
for those
who want a fairly strong
massage due to stiff
muscles.
Quick
Covers all areas using a
variety of massage actions,
all in a span of just five
minutes.
Recommended
for those
who want a quick, relaxing
massage.
1
2
4
1
Press the OFF/ON button.
The OFF/ON indicator will come on.
2
Select the pre-program you want.
Please press one of the flashing buttons.
If you press another Pre-Program button or a manual operation button during
your selected pre-program massage, the massage will switch to the newly
selected massage.
In pre-programs, the leg massage begins at the same time.
It is possible to stop or change the intensity of the leg massage during the
program. (See Page 13)
Pressing a Pre-Program button automatically moves the backrest and legrest
into massage position.
3
Sit as far back in the seat as possible with your head
centered on the pillow.
4
Adjusting shoulder position
When the shoulder position indicator is flashing, adjust the position of the
massage heads (upper heads) so that they lightly touch the shoulders.
Too high
Correct position
Too low
Lightly touching the
shoulder.
•
Up Down
Press
Press
Appr
oximate Height
6.0 ft. (185 cm)
5.2 ft. (160 cm)
4.5 ft. (140 cm)
5-Stage adjustment [up and down approx. 3.9 in. (10 cm)]
It is possible to change the position of the massage heads during the massage.
When it is not possible to correctly adjust the shoulder position, you may have to
slide your body and adjust it again.
•
•
•
•
•
•
•
•
•
About the Time Indicator
Time Remaining
Approx. 15 min.
Approx. 9 min.
Approx. 3 min.
Displays remaining massage time via flashing LED.
Starts counting down from 15 minutes in increments of approximately 3 minutes.
Flashing speeds up one minute before end of massage.
•
•
•
USING PRE-PROGRAMS AND QUICK MASSAGE
11-12 2008/07/31 15:18:59